hello
I am attempting to find a flanged idler and appropriate tensioner for a small machine I am building that will involve power transmission via a 1/4" width flat toothed belt. The machine will drive both directions and I do not desire a spring-loaded tensioner.
What I seek is a flanged idler pulley that I can mount on a simple tensioner with slotted holes to allow me to set the tension manually.
LANTECH::
30058337, TENSIONER DEVICE CHAIN ADJUSTABLE LINEAR 3/8-16 X 1-1/4 BOLT, EA . 31004045, PULLEY BELT TIMING HTD 32T 2.005IN PD 1IN WIDE 7/8 BORE 3/16 KEY
http://www.unisourceindyequipment.info/lantech.htmHOME |
DIY: GEN3 Timing Belt + Waterpump + Oil Seal Change - Part 1 ::
You will also need some flat washers due to the small head size of the M6 bolts. Remove the tensioner and idler pulleys (14mm bolts).
http://www.toyotanation.com/forum/showthread.php?t=264425HOME |
Ideally the idler pulley will be between 1" and 2" diameter (or in that general size range).
Any ideas of sources of such an animal?
Try a junkyard for auxiliary drive parts from an automotive engine. The tensioner on my old Honda Civic was not spring-loaded.
 Nortel Unveils Vision, Strategy for Israeli High-Performance Net
 Busy Friday Leads to Strong Close for Net Stocks
|
HOME